Can Enclosed Trailer Ramp Spring # CB250D96SHD be Cut Down for an 88 inch Wide Ramp Door

Question

Question:

Enclosed Trailer Ramp Spring - Dual, 96inch Wide Item # CB250D96SHD Can this spring assembly be cut down to work for an 88inch door?

asked by: Mike B

0

Expert Reply:

Yes the Enclosed Trailer Ramp Spring # CB250D96SHD that you referenced can be cut down to 88 inches if needed. The minimum length is 80 inches.

expert reply by: Jameson C

0

Answer 1

Your door is a little too narrow for the spring you mentioned but we do have a solution that is the correct size with the part #CB250D96SHD which has a 250 lb weight capacity and is for ramp doors that are between 80 and 96 inches in width.

view full answer...

Answer 2

When selecting ramp springs for a trailer ramp, you will want to know the diameter of your hinge pin and how much space you have available in the hinge. A typical horse trailer or utility trailer ramp uses 3/4 inch hinge pins and would require two…

view full answer...

Answer 3

The weight capacity of the Enclosed Trailer Ramp Spring #CB250D96SHD that you referenced is the capacity of the spring as a whole. It wouldn't be listed as total ramp weight since the length of the ramp and hinge used would end up making that…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The #CB250D96SHD is designed to work with trailer ramp doors that open from the top and when fully opened create a ramp used for loading the trailer. The brackets that are attached to the door are typically placed at the top of the door(top of door…

view full answer...

Answer 6

The Conventional Ramp Door Spring part #CB250D96SHD is designed for a trailer door measuring 80" to 96" wide with a hinged weight up to 250 lbs. In order to confirm fit, you'll first need to measure your door end to end. Then,…

view full answer...

Answer 7

Jared, the 150" long cables that come with the Conventional Ramp Door Spring for 8' Wide Enclosed Trailer #M354FR are unfortunately the only size offered with that part. What you could do instead, is buy the Replacement Cables for…

view full answer...

Answer 8

Jared, the Replacement Cables for Conventional Ramp Door Spring #M339FR is not going to work with the Conventional Ramp Door Spring for 8' Wide Enclosed Trailer #362SA8207 but it does work with the Conventional Ramp Door Spring for 8' Wide…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Can Enclosed Trailer Ramp Spring # CB250D96SHD be Cut Down for an 88 inch Wide Ramp Door

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching