Wire Gauge and Circuit Breaker Required for Brake Controller Isntallation  

Brake controllers allow you to vary the voltage applied to the trailer brakes to allow for different braking power. If the controller is set to it's max output voltage it should be right at 12 volts. Be sure to have the vehicle running too…

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

I have attached a diagram that shows how to wire a brake controller from scratch. If your truck did not come with a 7-way trailer connector, then you will also need to use the Installation Kit, #ETBC7. Your 1998 Chevrolet Pick up will not have a…

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

Tekonsha uses 10 & 12 gauge wire on their brake controllers. They use 10-gauge for the 12V and output and-12 gauge for the red and white.. We do not have replacement female-end connectors. We do offer the replacement male connectors for Tekonsha…

For your 12V wiring to your 7-way, we have people running many different things off that 12V wire. 12 gauge or even better 10 gauge ensures that the power is transferred timely and accurately. We have a kit for brake controllers and 12V wiring for…

On each individual electric brake magnet the amperage draw would be 3.0 to 3.2 max amps at 12 to 13 volts on 7-inch brake magnets and 3.2 to 4.0 max amps at 12 to 13 volts on 10 and 12-inch brake magnets. The max amperage draw for the brake magnets…

You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…

I contacted the manufacturer regarding the installation of the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR. They were able to provide me with a wiring diagram which I have included here for you.

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…