Replacement Snap-Ring Trailer Jack that Uses Original Mounting Bracket

Question:

The original jack on our trailer is welded on. The pull pin is jacked no pun intended up and we need to replace it. I would like to re-use the mounting bracket that is in place. Will this one work for that purpose?

asked by: Gary B

Expert Reply:

To determine if the Fulton Round Snap-Ring Swivel Marine Jack # FTJ120W0301 will be compatible with the existing bracket on your trailer, you will just need to measure the diameter of the welded mount.

The inner diameter of the large mounting hole at the center of the Fulton Jack mounting bracket is 2-1/2 inches. This also uses a 3/8 inch size pull pin. Also note that this Jack includes a new weld-on bracket that can be used if you are not able to use the existing bracket.

If the sizes match up, then you will also just want to make sure that the 1,200 pound lift capacity on this unit is sufficient for your trailer.

expert reply by: Chris R