Available 7-Way Wiring Extensions  

The proper extension for your setup would be the one that allows you to have clearance of your hitch mounted accessory and also allows you to still be able to pull the steps down. If the receiver tube sticks out past the camper too far then you will…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Hi Scott, Really good question and yes, all of the necessary hardware that is needed for installation comes with the Rhino-Rack Vortex Crossbars for Retrax XR and Mountain Top EVO-M Tonneau Covers #RRVA180B-RRRLT600. I've added a photo for you…

Great question, Kevin. The Onboard Scale system on your 2024 Ford F-350 Super Duty works by essentially measuring how low the bed is sitting and it gives an estimated weight based off of that. If you added a suspension enhancement then that would…

Hey Tim, the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will indeed fit your 2024 GMC 2500 AT4X with a factory suspension lift. You will likely need to use a spacer kit to compensate for the lift, depending on the amount of…

Hey Scott, We do have exactly what you need for both the rack and kit that allows mounting into the Vortex crossbars. It doesn't come with the bike rack so you'll need to get it separately, but what you're looking for is the following: -…

Yes, the Air Lift LoadLifter 5000 Air Helper Springs #AL57341 will fit your 2024 Chevrolet Silverado 2500 double cab with the Duramax diesel engine and factory puck system. We installed the upgraded Springs #AL88341 on a similar 2022 which I have…

Hey Jonathan, congrats on the new truck. The 7" drop should be enough, but it is hard to say for sure without knowing what trailer you will be pulling. The 7" drop will get your ball height at 17" or 18" (we measure from the upper…

Possibly since you have a 6-3/4' bed but you'll need to take a couple of measurements. I took a look at the nose of a 2024 North Point 310 RLTS. With how low of a profile it has and the kingpin extending out so far you should have plenty of…

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

Hi David, Rock Tamers require an inch of space on the ball mount shank in order to mount. If the portion of the shank exposed where you'll be installing the Rock Tamers is 2" x 2" then you'll want #ERT00108, for 2.5" x…