What Would Cause Front Axle Trailer Tires to Wear Out On the Insides but not the Rear
Question:
I have a 2016 reflection 337 twin axel. I noticed that my rear tires are wearing badly on the inside and front tires are wearing even. Tires only have 15 k miles. Any help would be appreciated. Thank you in advance for your assistance.
asked by: Ralph W
0
Expert Reply:
Is your trailer sitting level? It sounds to me like it is sitting with the nose too high and is putting more strain on the rear axle's tires.
I attached a help article that details how to pick out a ball mount to allow your trailer to sit as level as possible.
expert reply by: Jameson C
0
Product Page this Question was Asked From
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/2" Long - 7.5K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- Class III
- 7500 lbs GTW
- Draw-Tite
more information >
Featured Help Information
Miscellaneous Media
Similar Expert Q&A Pages
- Is it Okay for Ball Mount to Move in Trailer Hitch Receiver Some
- Recommended Trailer Hitch and Trailer Wiring for 2017 GMC Terrain
- Trailer Hitch Fits Recommended for 2013 Subaru Crosstrek
- Which Vehicle Will DaLan Class III Hitch # 13217 Fit
- Long Ball Mount and Hitch Extension for 2000 Ford Excursion with Dual Rear-Mount Spare Tires
- How to Determine Pin Weight of Fifth Wheel Trailer
- Which Ball Mounts are Manufactured in the USA
- How to Determine Which Drawbar I Need For My Vehicle
- Can All Ball Mounts Be Used in Both the Rise and Drop Positions
- How To Measure For Ball Mount Rise Or Drop On 1999 Chevrolet Silverado
- Ball Mount and Anti Rattle Lock Recommendation Similar to Boss Anti Rattle Ball Mount
- Where is Ball Mount Length Measured
- Why Can't Weight Distribution System be Used on 2018 VW Atlas
- How to Find the Correct Ball Mount for 2018 GMC Acadia and Boat Trailer
- Ball Mount, Balls, and Trailer Wiring Recommendations for a 2007 Volvo XC90 with Draw-Tite Hitch
- Availability of 2 Inch Ball Mount With a Rise Between 3/4 Inch and 1-1/4 Inch
- How to Determined the Correct Rise or Drop Needed for a Ball Mount to Tow a Trailer Level
- Can Volkswagen Touareg Use Weight Distribution When Towing
- Husky Weight Distribution System Recommendation for a 1,000 lb Tongue Weight Trailer
- Ground Clearance between Trailer Hitch and Ground on a 2009 Subaru Forester
- Recommended Ball Mount for 2013 Honda Pilot
- Accounting for Tow Vehicle Sag when Choosing Ball Mount
- Rise or Drop of Ball Mount Needed for Rental Trailer
- How to Eliminate Rattle Between Ball Mount and Receiver While Towing
- Choosing Extended Length Ball Mount to Provide Maximum Clearance Between Trailer and Tow Vehicle
- Eliminating Ball Mount Rattle
- How to Pick Out the Correct Rise/Drop Ball Mount for a 2013 Toyota Tundra Towing a Boat
- What is the Towing Capacity of a 2013 Ford Edge 3.5L TiVCT
- Tongue Weight of Jayco 27BH Trailer That Has a Dry Weight of 7,500 Lbs