bing tracking image
Q & A Icon

How to Determine What Landing Gear is Needed for a 1995 Westport 34

Question:

I have a 1995 Westport 34 5W . I need to replace the landing gear, i do not know what landing gear is in it. can you help me out?

1

Helpful Expert Reply:

In order to pick out a direct replacement for the landing gear on your 2007 Desert Fox 38U we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.

I attached a picture that shows the dimensions that this landing gear set would fit with.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.

click to enlarge
helpful expert reply by:
1
Jameson C

Products Referenced in This Question


Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>