Ball Mount with 4 or 5 Inch Rise for a 1-1/4 InchCurt Hitch on a 2016 Honda HR-V  

Yes! We can help you with both of these items. Replacement hitch hardware can be ordered by itself simply by entering the part #RHK into our search box, and then entering the hitch part #36520 and selecting Draw-Tite from the drop-down menu. I have…

I have a solution, however the Master Lock Hitch Receiver and Coupler Latch Lock Set #2848DAT does not offer a 1/4" only kit. What we do have is the Trailer hitch Receiver Lock #5200 is a single lock that will fit 1 1/4" x 1 1/4"…

The Curt Class II trailer hitch you referenced, part #C12038 has a 3500 lb towing/350 lb tongue weight capacity. If you'll only be using the hitch for towing a trailer, it should work just fine for you. However, if you're wanting to use the…

To find the right ball mount you need to tow your Coleman Popup Camper level you can take a couple of quick measurements. Park the trailer and your RAV 4 on level ground. Measure from the top of the trailer receiver opening to the ground. Then…

For your 2020 Honda CR-V, the Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" #36597 has a shipping weight of 24 lbs and the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13397 has a shipping weight of 30…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The ideal height will actually have to do with how tall the coupler of the trailer is from the ground. The Draw-Tite #76020 will sit at 13 1/2 inches from the ground to the top of the hitch when installed on a 2016 Mazda CX-9. From what I could find…

Based on your measurements it matches our Fulton 50-Degree A-Frame Coupler #FE443050303 which looks to be the same as what is on the 2024 Intech Sol Horizon from the videos I could find. So this would use either the EZ Latch #DM14793-81 or…