Replacement Landing Gear for 2009 Carri-Lite 36XTRM 5th Wheel

Question:

I have a 2009 carri lite 36xtrme i need to replace my front landing gear. Where can i get them

asked by: Ranson W

Expert Reply:

In order to pick out a direct replacement for the landing gear on your 2009 Carri-Lite 36XTRM 5th wheel we would need to know the distance between the mounting brackets. Please see the linked photo.

Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets that come with # BD500162.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement. The picture I attached shows the dimensions needed for the Ultra Fab. If the dimension in red is 17-1/2 instead then the Bulldog or the Lippert # LG-1 would fit.