bing tracking image
Q & A Icon

Needing New Trailer Hub for a 1962 Aloha 16 foot Trailer

Question:

Needing new hub My inter bearing is LM 48548 and the bearing race is lm 48510 My outer bearing is stamp m12649 I have a 5 on 41/2 wheel spacing on 15 in wheel My axel is from a 1962 aloha trailer 16 ft Axel is 1 n a half in thick Thank u for any information

0

Expert Reply:

I do have a way that you can put replacement hubs on your 1962 Aloha Trailer, but unfortunately we do not have any hubs that use those bearings.

If you are restoring or updating this trailer then it may be easier to just replace your axle so that you can easily find replacement parts.

You can try matching the leaf spring and spring center measurements of our standard axles so they match with your trailer, but I recommend using a Timbren Rubber Spring Suspension instead. The Timbren Axle-Less suspension is much easier to install than the traditional axle plus it can increase the ground clearance of your trailer. You could use part # A35RS545 which include the hub assemblies that have a 5 on 4-1/2 inch bolt pattern, and use the common Inner Bearing # L68149, Outer Bearing # L44649, and Grease Seal # RG06-050.

I have attached an installation video for you to reference should you choose to go this route.

click to enlarge
expert reply by:
0
Jon G

Products Referenced in This Question




Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>