How Much Grease Should be Added to the Bearing Buddy Bearings  

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

A great majority of standard ball mounts are designed so that they can be used in either the drop or rise position. Using a ball mount like the Draw-Tite #2753 that you were looking at in the rise position is just a matter of turning it upside down…

The great thing about Bearing Buddy like part #BB1781 is that when you add grease to your system with the included fitting, it will move the spring-loaded piston outward and allow grease to seep around the edges to keep from damaging the seal. You…

Using a Bearing Buddy to grease a hub can easily allow you to over fill the hub and blow out a seal. The zerk fitting where you insert the grease is sitting on a spring loaded disc or piston that will move outward away from the hub as grease is…

The guy you were speaking with was telling the truth. If the Bearing Buddies are overfilled, you will indeed blow out the grease seal. The excessive pressure will push the grease out through the rubber portion of the seal. Using a double lip grease…

Bearing Buddy pumps grease into the center of the hub all the way back to the grease seal. A double lip seal should be used to prevent grease from blowing out the seal when added. When the hub and seals and bearings are first assembled, they should…

15/16 is .937 inches so your measurement comes out to 1.937 inches which is slightly smaller than the 1.938 inch diameter of the Bearing Buddy Model #BB1938. I believe this will be the correct part for your hub since there is not another bearing…

For your dust cap that measures 1-15/16 inches (1.937 inches), the Bearing Buddy part #BB1938 that you referenced would be the correct part confirmed to fit.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Jeff, based on your axle info the correct bearing kit would be the part #BK3-310 for a kit that includes both bearings #LM67048 and #25580 as well as a grease seal. This would be all that you'd need as you can reuse the dust cover.

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…