Availability of White Lid Version of MaxxFan Deluxe Roof Vent # MA00-06401K  

What you need to do is measure the size of the opening on your trailer's roof, which you can do be removing the vent as well as the garnish around the vent. If you did this and only got 13-3/8" x 13-3/8" I highly recommend…

You'd want to use the non-sag sealant part #344270341437-1 on vertical applications where you wouldn't want the sealant to drip or run. The #34427034145-1 is better for horizontal applications as it's self-leveling, but it…

Not to worry! You can absolutely install your MaxxFan Deluxe Roof Vent w/ 12V Fan - Manual Lift #MA00-06401K in the other direction, it will not affect the operation of the fan. You will just want to make sure that your fan stays closed while…

The LaSalle Bristol XTRM Self-leveling Sealant part #34427034145-1 is very comparable to the Dicor 501LSW self leveling lap sealant. I can't say exactly what the formula is for Dicor but I can tell you that LaSalle Sealant is a silicone…

The roof vents that we carry require a 14-1/4" x 14-1/4" opening for installation. Since you have a pop up it wouldn't be a drastic change to trim out your 11.5" x 11.5" opening to fit a larger vent like…

Changing the polarity of the MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-06401K would likely burn out the circuit board. The #MA00-06401K is designed to move air out of your trailer when the vent cover is open or pull air in and circulate the air…

Based on what you described wanting the MaxxAir MaxxFan part #MA00-04751KSX is your best option. This has a 4 speed fan, a powered lift, and has no thermostat. I attached a review video for this for more info as well.

We have a white MaxxFan vent roof with power lift and fan with the part #MA00-04751KSX which also does not have a ceiling garnish.

If you've got a Maxx Air MaxxFan Plus like the #MA00-04751KSX you can use the MaxxAir FanMate RV and Trailer Roof Vent Cover - 25" x 18-1/8" x 10-1/4" - Smoke #MA00-955003, which is designed to fit 2015 and newer MaxxFan and…

I reached out the manufacturer, Airxcel, and was informed that all of their fans, including the #MA00-05301K, have motors with brushes and ball bearings in them.

The most cost-effective Maxxair roof vent that is similar is the part #MA00-05301K to the #MA00-07000K. The frames are basically same so I would assume you could interchange like you are wanting.

As long as the gutter on your 2007 Itasca Suncruiser has a spout the part #CAM42123 will fit and work well.