Will the Yakima Mounting Hardware # Y8860040 Fit Factory Crossbar of 2014 Ford Explorer XLT  

The Replacement Mounting Hardware #Y8860040 will fit a crossbar up to 3-7/8" wide and 1-1/4" tall. As I do not have access to the size information of the factory crossbars on your 2014 Land Rover Range Rover you will need to measure your…

Your picture didn't make it through but we do know that the Buttondown uses the MightyMounts part #Y03590 to attach to factory or aero shaped crossbars.

I called my contact at Yakima and asked about T-slot adapters that can be used with the PowderHound ski carriers. Unfortunately they do not have any T-slots that will work with the carrier and the only mounting hardware they offer is the #Y8860040.…

For replacement hardware for a Yakima Button Down that allows it to fit aero shaped bars you would need the part #Y8860040.

The Yakima mounting hardware part #Y8860040 that you referenced will fit older and newer style ButtonDown racks so if you are looking for a replacement clamp this will work. It also fits wider crossbars than the non-aero Buttondown will fit. This…

I spoke a representative from Yakima about the Lift Brackets for Yakima ReelDeal or Big PowderHound and PowderHound Carriers - Qty 2, part #Y8860037. They said these brackets will give you almost 4" of additional clearance. The lift brackets do…

Yes, the Replacement Lock Housing and Fastener for Yakima Q-Tower #Y70026 will fit your Yakima Buttondown Ski carrier and will provide a mounting point for your SKS lock cores.

For the Replacement Mount, part #Y8860040, the measurement from the top of the saddle to the mounting point is about 1-3/4 inches, while the distance from the center of the clamp to the top of the mount is about 2-1/8 inches.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…