What is the Bolt Hole Pattern for Pro Series Round, Snap-Ring Swivel Jack, # PS1400300303
Question:
Please provide the center to center bolt hole distances for the mounting plate on the Pro Series Trailer Jack - PS1400300303. Thank you.
asked by: Don S
0
Expert Reply:
For the Pro Series Round, Snap-Ring Swivel Jack, # PS1400300303, the bolt hole pattern on the mounting plate is 4-1/2 inches by 5-3/8 inches. The mounting plate can be turned 180 degrees to use these measurements either way.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Replacement Dutton-Lainson Trailer Jack 22457 or 22560
- Article: Best RV Roof Vents
- Q&A: Relocating License Plate and Bracket on a Utility Trailer
- Q&A: Diameter of Croassbars for Erickson Truck Bed Ladder Rack
- Q&A: Can License Plate be Placed on Top of Tail Light Assembly of Detail K2 Mighty Multi Utility Trailer
- Q&A: Can I Upgrade 3,500 lb Axles to 5,200 lb Axles
- Q&A: Correct Brakes for Big Tex Tandem Axle Trailer with 8-249 Hub
- Article: Most Popular Wheel Bearings
- Article: Trailer Jacks
- Article: How to Measure a Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Wiring Diagrams