What is the Standard Bolt Pattern for Pintle Hooks
Question:
Need to replace bolt on pintle hook with mounting pattern of 3 /38 and 1 3/4inch with bolt on 2inch receiver tube with same bolt pattern. Thanks
asked by: Bruce
0
Expert Reply:
Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part # C48231 would be a direct fit and work well for you. It also comes with all the mounting hardware needed for installation.
I have attached a review video of the above hook for you as well.
expert reply by:
Conner L
0
click to enlarge
Product Page this Question was Asked From
Curt Pintle Hook - Bolt On - 60,000 lbs
- Pintle Hitch
- Pintle Hook - Standard
- 60000 lbs GTW
- 4 Holes
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Curt Pintle Hook - Bolt On - 60,000 lbs
- Shop: Buyers Products Weld-On Pintle Hitch Plate - 34-1/2" Wide x 22-1/2" Tall
- Shop: Trailer Hitch
- Shop: Curt Pintle Hook - Bolt On - 30,000 lbs
- Q&A: What is the Bolt Hole Pattern for Mounting the Curt Trailer Hitch Receiver # 13018
- Shop: Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable - 300 lbs
- Shop: Brake Controller
- Shop: Even Rub Rail Trim for Enclosed Trailer - 1-1/2" Tall x 1/8" Deep - Aluminum
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Pre-Greased
- Shop: Trailer Wiring
- Shop: Gooseneck Hitch
- Shop: B&W Pintle Hook Mounting Plate for 2" Hitches - 13" Shank - 14 Hole - 16,000 lbs
- Search Results: light box
- Shop: Vehicle Tow Bar Wiring
- Search Results: red reflector
- Q&A: What is the Bolt Pattern for the Buyers Products PH50 Pintle Hook?
- Q&A: Dual Propane LP Tank Setup 100 Lb for RV or Travel Trailer
- Video: In-Depth Review of the Pintle Lock for BulletProof Hitches Adjustable Ball Mount
- Video: Let’s Check Out the Super Titan Trailer Hitch Pin and Clip for 3" Receivers
- Video: All You Need to Know About the Super Titan Forged Pintle Hook Plate for 3" Trailer Hitches
- Shop: Towing Mirrors
- Q&A: Trailer Tires are Wearing On the Inside Tread with Low Miles on the Tires
- Q&A: Is it Normal for Pintle Hook Towing Setup to Make Noise When Starting/Stopping
- Q&A: Recommended Pintle Hook for the Reese RP38186
- Q&A: Can You Use a 5/8" Hitch Pin On 3" Hitch with 3/4" Hitch Pin Hole
- Shop: Suspension Enhancement
- Search Results: pintle hook
- Search Results: lunette ring
- Search Results: hitch pin
- Search Results: bulletproof hitches