How To Determine if Fulton Round, Snap-Ring Swivel Jack # FTJ120W0301 Will Fit Existing Weld Mount  

Question:

Expert Reply:

To determine if the Fulton Round, Snap-Ring Swivel Marine Jack, part # FTJ120W0301, will fit on your existing weld mount on your trailer you will need to measure the diameter of the weld mount on your trailer. The inner diameter of the large mounting hole on the center of the mounting bracket for Fulton Jack, # FTJ120W0301, is 2-1/2 inches. The Fulton jack also uses a 3/8 inch size pull pin.

This jack will also come with a new weld-on mounting bracket in case it will not fit your older mounting bracket.

You will also want to make sure the 1,200-lb capacity on the Fulton jack is sufficient for your trailer.

expert reply by: Jeff D

0