Replacement Vent Cover for Fantastic Vent 4000r  

I had the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR measured and the distance from the center of the crank bolt to the top of the mounting flange is 2-1/2".

Without a model #for your Fan-Tastic Fan there's no way to 100% confirm the fit but I can confirm that the replacement domes we do carry #FVK1020-19 (smoke) and #FVK1020-81 (white) will fit the following models: FV801200, FV801208, FV801250,…

Yes, the Tinted Replacement Dome for Dometic FanTastic RV Roof Vents #FVK1020-19 is also available in White as part #FVK1020-81. Attached is an installation video for you to check out.

I confirmed with Dometic in the past that they only carry two styles of lids for the Fan-Tastic Vent line; flat or dome. From there you can then just choose your preferred color. If you have a Fan-Tastic Vent RV roof vent then you'll just need to…

I have a solution for you, but because Winnebago does not have a company that they allow to make aftermarket lights for, we won't have an exact replacement for the Winnebago part #113709-01-000. I recommend going with the Peterson Thin Line…

Since we don't have a confirmed fitting replacement for a 7300 I recommend taking a few measurements of your current cover's mounting hole locations and seeing it will match up to the Replacement Dome for Fan-Tastic Vent RV Roof Vents -…

You likely can use any replacement switch since all they do is complete a circuit when the pin is pulled out. One wire on the switch should be connected to the positive battery terminal on the trailer. The other will tee into the wiring leading from…

The needed replacement part in smoke/tinted is, #FVK1020-19; this fits all 4000 series units like what you have on your motorhome.

Yes, it looks like your existing Fan-Tastic Fan model 4000BT is a standard 14" wide x 14" long roof vent so the MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat part #MA00-05100K would fit the opening for your old vent as long as the roof…

Dielectric grease is basically just applied in a thin coating to the connector plug. You can use #11755 or #LT37534 if you prefer a smaller amount. I've attached a video to assist. Just like the connection on the back, you can add this to the…

The Replacement 42" Cable for Breakaway Switch from Bright Way Group, #3802350, will fit most models of ESCO break away switches. If you don't want to take a chance on it not fitting, I would instead recommend replacing the switch with part…

We do have all the parts you need to flat tow your 2019 Ram 1500 with the new body style and 3.6L engine, and I'd be happy to make a list for you so you know what to get. That said, all of the parts needed to flat tow your truck are as follows: -…