Replacement Tail Lights Needed for Monarch # 5237 Tail Lights
Question:
I have Monarch #5237 tail light and would like to covert to led. My problem is that they fit in a pocket with space for 2 1/2 inch tall by 2 7/8 deep. Do you have anything that would fit my needs?
asked by: Jim T
0
Expert Reply:
The closest LED option that we have to your Monarch # 5237 tail lights is the Optronics LED Trailer Light Kit # TLL160RK. These measure 2-7/8" tall, 8-1/16" wide, and 2-13/16" deep.
The kit will fit as far as depth goes, but they are slightly higher than what you currently have.
I have attached a picture showing the dimensions as well as a review video for you to check out.
expert reply by:
Jon G
0
click to enlarge
Product Page this Question was Asked From
Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Trailer Lights
- Tail Lights
- License Plate
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 8L x 3W Inch
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Optronics LED Combination Trailer Tail Lights - Submersible - 40 Diodes - Driver and Passenger Side
- Q&A: Looking For Tail Light To Replace Monarch 5236 Lights
- Search Results: stl17rb
- Shop: Vehicle Engine Heaters
- Shop: Folding Steel Ramp for Pro Series Solo Cargo Carrier - 48" x 31-1/2" - 400 lbs
- Shop: LED Combination Tail Light for Trailers over 80" Wide - Submersible - Red - Passenger Side
- Shop: ONE LED Combination Trailer Tail Light - 8 Function - Submersible - 1 Diode - Driver Side
- Shop: Trailer Hitch
- Search Results: trailer lights
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 72" Long - 2,000 lbs
- Shop: GLOLight LED Combination Trailer Tail Light - 6 Function - Submersible - 28 Diodes - Passenger Side
- Shop: ONE LED RV Combination Tail Light w/ License Plate Bracket - 4 Function - 1 Diode - Driver Side
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Search Results: led trailer light replacement
- Video: A Closer Look at the Quick Splices
- Article: Trailer Lighting Requirements
- Shop: Gooseneck Hitch
- Shop: Trailer Wiring
- Q&A: Best Way For Connecting The Brown Side Marker Light Wire To A Boat Trailer
- Q&A: How Does Trailer Running Light Circuits with Yellow/Brown and Green/Brown Wires Run to New 4-Way
- Q&A: How To Install New 4-Way on Trailer with Brown/Green and Brown/Yellow Wires
- Q&A: Trailer Wiring Has 5-Wires White, Yellow, Green, and 2 Browns
- Q&A: Recommended Replacement Options For A Bargman Interior Dome Light # 30-73-011
- Video: Trailer Wiring Harness Installation - 2016 Honda CR-V
- Search Results: trailer awning
- Search Results: wells cargo trailer parts
- Search Results: trailer wiring tester
- Search Results: light covers
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Taillight Solution for Lens Number S2T216AP2
Jeffk
12/10/2024
Same problem, tailer companies used steel tubing 2&1/2" high. Obviously, you can't make that steel larger and companies make the lights to large to fit. 3/8" is a lot try to fit. I tried to use a belt sander but it's a lot to take off.?? What was a good mount, is now frustration.