Transmission Cooler Recommendation for a 2012 Nissan Titan 4x4  

Even though your 2005 Nissan Armada already has a transmission cooler you can absolutely add a secondary cooler because fluids will not over-cool. In regards to fit, the rule of thumb with aftermarket transmission coolers is you want to get the…

You can definitely bypass the factory cooler of your 2012 Nissan Armada with a supplemental one like the part #D13502. You would just route the fluid through it and then back to the transmission. A better option would be a larger cooler like the part…

The Derale Series 8000 Plate-Fin Transmission Cooler Kit w/Barb Inlets part #D13503 would be what I recommend for the 5.6L V8 engine in your 2012 Nissan Titan. As long as you have 11" wide x 8-3/4" tall x 7/8" deep of space to mount…

The best way to pick out a transmission cooler is to measure the distance in front of the radiator and AC condenser and pick out the biggest one that would fit reasonably. The Derale Transmission cooler part #D13503 is a very popular cooler with…

For the best possible cooling of the transmission fluid you ideally would want to route the fluid through both coolers as this would give you the best results. That being, there are several people who will replace their coolers with supplemental ones…

Given the weight of your trailer and the fact that you tow uphill I recommend going with the largest cooler or most efficient that will fit in the available space you have in the engine compartment of your 2004 Silverado. A stacked plate cooler is…

Firestone offers spacers that are supposed to be used with their Ride Rite kits like the part #F2299 if the vehicle has a lift like you mentioned. For the lift you mentioned being between 1.5 inch and 2 inch we have the spacer kit part #F2536 which…

You are correct. Since you have a 1-1/2 inch "lift" on your truck you'd need the Firestone 1-1/2 inch spacer kit part #F2536 to take up that additional space.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…