Spindle Nut Washer and Grease Seal for a Dexter 3500 Pound E-Z Lube Trailer Axle
Question:
Looking for the spindle nut lock washers for a Dexter #3500 ez-lube axle. It is on a 2001 US Cargo open car hauler. Which part is correct part number a Redline 5-71 or a TruRyde 5-101? What is the part number for the seal for it as well? Thanks
asked by: Darrin
Expert Reply:
The Replacement Spindle Washer, # 5-101, was designed specifically for E-Z Lube axles, so that should be the correct washer for you. You can make sure that your spindle has a 1 inch diameter at the end where the washer will be.
It sounds like you have a #84 spindle which is for 3500 pound E-Z lube axles. The correct seal would be # RG06-050, for a pair of double lip seals. To be sure, you would need to find the bearing numbers of the inner and outer bearings. The numbers are stamped into the metal.
Products Referenced in This Question
Replacement Spindle Washer - Tang Type for E-Z Lube
- Accessories and Parts
- Trailer Spindles
- Spindle Washer
- 1 Inch I.D.
- TruRyde
more information >
Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.719 Inch I.D.
- 2.565 Inch O.D.
- etrailer
more information >
Product Page this Question was Asked From
Tang Replacement Spindle Washer
- Accessories and Parts
- Trailer Spindles
- Spindle Washer
- 1-1/2 Inch I.D.
- Redline
more information >
Similar Expert Q&A Pages
- Inner Diameters of Tang Washer Type B
- Trailer Spindle Washer with a 1-1/2 Inch Inner Diameter
- Replacement Spindle Washer for Axle with Bearings that are 1-3/8 and 1-1/16 inch
- Inner Diameter of Tang Spindle Washers Close to 1-5/8 Inches
- Tang Style Washer for Trailer Spindle with Castle Nut
- Tang Spindle Washer With 1 inch Diameter
- Type of Spindle Washer Used on Boat Trailer Spindle with a Notch/Slot on Spindle
- Replacement Washer for an EZ Lube Trailer Spindle
- Replacement Spindle Washer For 3,500 Lb EZ Lube Spindle
- Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Availability of Dexter Part Numbers 005-070-00 006-096-00 005-071-00 010-050-00 021-036-00 046-032-0
- Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Tongue Washer Compatibility with Trailer Spindle and Tapered Bearings
- Causes for Hub Castle Nut to Come Loose After Installing and Using Hubs
- Is a Spindle Washer Needed Between the Spindle Nut and Outer Bearing on Dexter 5 on 4-1/2 Hubs
- Availability of Trailer Spindle Washers with Tabs
- Inner Wheel Bearing Recommendation for a Number 84 Spindle
- Replacement Spindle Washers For An Old Trailer With 10k Axles