Replacement Trailer Fender that Measures 36 x 10 x 17 Inches  

If you used strong enough brackets when installing the Single Axle Trailer Fender #CE18041ATB they'd be strong enough to support people of all shapes and sizes. These don't have a specific weight capacity but they are pretty strong. Normally…

There's no reason the L-brackets part #CE26098G-2 wouldn't work with the fenders part #HP29VR that you referenced. They would actually work really well.

We do have a large selection of trailer fenders available that will work nicely with your 15 inch wheels. I recommend taking a look at the CE Smith Single Axle Trailer Fender #CE18041ATB. This is a really nice, aluminum fender that features a diamond…

The aluminum that the Single Axle Trailer Fender #CE18041ATB you referenced is made from is 14 gauge which is .064 inch/1.63 mm thick.

The Aluminum Tread Plate, Jeep-Style, Single-Axle Trailer Fender, item #HP96VR is designed for a weld on application and putting screws and washers through the lip on the inside of the fender would most likely not last. If these fenders were to be…

When it comes to replacing your fenders on your 2010 10x6 Hallmark Transport Trailer you indeed can install The Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13 inch to 15 inch - Qty 1 #HP96VR. When attaching the fenders #HP96VR to…

If your breakaway battery is dead, your brakes should operate while connected to your vehicle's 7-way trailer connector. If your brakes are not operating, then it sounds like you might have a short in the brake wiring of the trailer. Battery…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…