bing tracking image
Q & A Icon

Is There a Fitting for Titan Brake Actuators Solenoid?

Question:

Hello. On the back of the solenoid, there is the brass fitting where the brake line is connected. Can that fitting be removed, and a different connector attached? The connector installed is straight-out with a compression fitting. It would be better for my installation if I could attach a 90-degree connector so the compression fitting is directed down. My brake line would then be a direct connect w/o trying to bend the line.

0

Expert Reply:

The solenoid on a Titan Zinc-Plated Brake Actuator # T4748800 cannot have the solenoid's brass fitting be removed and replaced. This part is not something that you will be able to adapt or re-configure with this actuator.

expert reply by:
0
Kyle S

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>