Where to Measure to Pick Out Correct Lippert SolidSteps for RV  

It is possible that you will be able to switch out your current MORryde 3-step RV steps to a MORryde 4-step, like the MORryde StepAbove RV Steps for 27-3/4" to 30-1/4" Wide Doorways - 4 Steps #MR28RR, but it will depend on a couple…

Sounds like either your fifth wheel rails weren't install properly in the bed of your truck or your fifth wheel hitch has somehow been bent. What you will need to do is check out the picture I attached that has all of the industry standard…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…

Hey John, The Gen-Y Hitch 5th Wheel to Gooseneck Pin Box #GY98GR has a matching bolt pattern to your Rhino Box pin box. You will want to check your 5th wheel's pin weight to ensure the 3.5K model is going to be the right capacity though. With a…

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

Thank you for the photo of your 2016 Ram 3500's bed rail which sits 59-inches above ground. You are correct that the recommended minimum clearance between a bed rail and the underside of the trailer's overhang is 5 to 6-inches, as shown in…

Hey Nathan, we have a solution with the MORryde StepAbove #MR26RR but the Lippert step you mentioned does not fit your RV doorway width. The MORryde StepAbove is basically the same thing made by a different company with slight differences.

I spoke with my contact at Trailair and from your serial number we were able to determine that your trailer came with a 1621 HD pin box which is a long pin box style. I was unable to obtain the exact part number for your Trailair pin box but from the…