Troubleshooting Shorted Out Brake Controller Connected to Breakaway System
Question:
Hello, Hooked up my truck to our 24foot Carson enclosed trailer that we just installed a new breakaway battery on. Immediately fried the controller. Short to ground somewhere in the harness? Thank you
asked by: Jeremiah H
Expert Reply:
I'm sorry that this happened to your brake controller. I am happy to do research to help get this issues resolved.
If when testing the breakaway system and the pin was pulled with the battery connected backwards. This would compromise the brake controller. When reaching out to my contact at Tekonsha we agreed that there may be a wiring issue someplace in the breakaway system. The combination of the wiring issue, combined with pulling the pin would certainly cause frying of the brake controller.
The break away system on a trailer would typically have its own battery, like that shown with part # 20400. The break away switch should be wired so that it is a normally open circuit that closes when the pin is pulled. When the pin is pulled, the circuit closes, allowing voltage to travel to the trailer brakes. One leg of the switch should be wired to the positive terminal of the break away battery, and the other leg tapped into the brake circuit (see provided diagram.)
Once you have everything wired as shown in the diagram, the system should work fine for you.
Product Page this Question was Asked From
Hopkins Engager Trailer Breakaway Kit w/ Charger, LED Tester, Hardware, and 5 Ah Battery - Top Load
- Trailer Breakaway Kit
- Kit with Charger
- Top Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Search Results: 7 way plug
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Q&A: Does it Matter Which Wires are Power or Ground for Electric Trailer Brakes
- Q&A: Bolt Torque Specification for Mounting a 12 Inch Brake Assembly
- Q&A: Should Dead Trailer Breakaway Battery Cause Trailer Brakes to Not Work
- Q&A: How Tight Should the Spindle Nut be on a Dexter 8,000 Pound Axle
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Q&A: How do I Tell if the Brake Controller is Bad
- Q&A: Electric Trailer Brake Magnet Short Circuit Indicator on Brake Controller Comes On After Moving
- Search Results: center wheel caps wheel covers hubcaps
- Search Results: fastway lock
- Search Results: fortress lock
- Search Results: 7000 lb axle brakes
- Shop: Hopkins Engager Trailer Breakaway Kit w/ Charger, LED Tester, Hardware, and 5 Ah Battery - Top Load
- Shop: Dexter Trailer Hub and Drum Assembly - 5,200-lb to 7,000-lb Axles - 12" Diameter - 8 on 6-1/2
- Shop: Fastway Universal Coupler Lock for 1-7/8", 2" and 2-5/16" Couplers - Key 317
- Shop: Nerf Bars - Running Boards
- Search Results: 51120
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Search Results: 21~88
- Shop: Replacement 12V 5 Ah Battery for Bright Way Trailer Breakaway Kits
- Shop: Replacement Oil Cap Kit for 9,000-lb and 10,000-lb Dexter Axle
- Article: Trailer Wiring Diagrams
- Shop: Towing Mirrors
- Video: Hopkins Trailer Breakaway Kit Review
- Video: Buyers Products Class 4 Trailer Safety Chain with 1 Clevis Hook Review
- Video: Detailed Breakdown of the Buyers Products Weld-On Safety Chain Retainer For 5/16" Chain
- Video: Breaking Down the CargoSmart Forged Steel D-Ring Tie-Down Anchor
on Trailer Breakaway Kit
