bing tracking image
Q & A Icon

Recommended Trailer Wiring Harness for 2006 Chevy Colorado

Question:

We have a Hopkins 7 blade/4 pin connector installed on our 2006 Chevy Colorado. We needed the 7 blade and for the camper and the 4 pin for the boat. Diagram shows yellow is left and brake and green is right and brake, with brown being the tail light. The problem is our brake and tail lights are both the top light and the turn signals are the middle light. Turn signals work on the trailer but break and tail lights don’t.

0

Expert Reply:

You have a 3 wire system, so you will need to use the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118301 to convert the wiring on your 2006 Chevy Colorado. This custom-fit T-One connector plugs into your Chevrolet Colorado's wiring harness, which is located beneath the truck bed, near the driver's-side frame rail.

This harness will convert your truck wiring into the traditional trailer wiring you stated to fit with your Hopkins 7-way and 4-way Connector. If you mean that your camper light wiring has the separate brake and turn signal, then you will need the Vehicle to Vehicle Tail Light Converter # C56196 to separate the functions on that wire.

expert reply by:
0

Products Referenced in This Question



Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>