How Far Down to Arms on Thule Hullavator Extend for Kayak Loading

Question

Question:

How far down the side of care does the kayak loading arms extend? Curious if it will help lift my 80lb Hobie outback on top of my GMC campershell

asked by: Jason D

0

Expert Reply:

The Thule Hullavator Pro Kayak Carrier # TH898 referenced in your question will sit 40 inches lower than the top of the roof rack crossbars when extended down for kayak loading. Please note though that this particular carrier does have a 75 pound weight capacity so your 80 pound Hobie Kayak will be exceeding its limit.

Another option that will provide some assistance with loading your heavier kayak is the Yakima Kayak Carrier # Y04083-04082. This system includes 2 padded rollers that will allow you to load the kayak up from the rear of your truck and push it the rest of the way. 2 flexible saddles will provide support once it is in position. Load straps and bow/stern tie-downs are also included to secure the kayak into place. It has an 80 pound weight capacity.

I have attached a short video demonstration on this carrier that you can also check out.

expert reply by: Chris R

0

Answer 1

There is not a general restriction from Thule that says two Hullavator Kayak Carriers #TH898 can't be used on a Thule roof rack. As long as the crossbars on your Ford Escape have the required length for two sets and a sufficient weight capacity…

view full answer...

Answer 2

For your 2018 Honda HR-V to be compatible with the Thule Hullavator Pro Kayak Carrier and Lift Assist with Tie-Downs #TH898, you have to use slightly longer crossbars. The Hullavator requires 4-8 inches overhang to give clearance. In order to give…

view full answer...

Answer 3

Yes, we do. To carry the Thule Hullavator item #TH898 on your 2021 Jeep Gladiator Sport, I recommend the roof rack by Rhino Rack and it includes the following parts: Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 71" Long - Qty 2 item…

view full answer...

Answer 4

There are two ways to connect the Thule Hullavator to your crossbars, clamp on or use the T-slot. Clamp on requires square bars and T-Track requires a Thule Crossbar. If you have raised side rails on your vehicle, the SteelTop #MPG203 will just clamp…

view full answer...

Answer 5

I may have a solution for you, but your 53" bars are not going to be sufficient for this task. The Thule Hullavator #TH898 requires 28.5" of usable bar space with 4"-8" outside of the rails/towers, in order to function properly;…

view full answer...

Answer 6

The Thule Hullavator Pro Kayak Carrier part #TH898 comes with the attachments that you will need for the channels/tracks on your Rhino-Rack Vortex Aero Crossbar so you will not need anything else for this. However, the Hullavator requires that you…

view full answer...

Answer 7

Sliding a kayak across the rubber pads on the Lockrack #LR24VR really won't be much different than normal crossbars/kayak carriers, though I recommend picking up some silicone spray from a local home improvement store and keeping the rubber…

view full answer...

How Far Down to Arms on Thule Hullavator Extend for Kayak Loading

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching