Can LED and Incandescent Lights be Used at the Same Time on a Boat Trailer  

For trailers that are over 80 inches wide, less than 30 feet long, and have a gross weight rating of 10,000 pounds or less I have the following lighting requirements: 2 brake lights 2 tail lights 2 turn signals 2 rear reflectors 1 license plate light…

It sounds like you have something like the Amber Lens #MCL0032ABB at the front and the Red Lens #MCL0032RBB at the back of your fenders. Normally these lights are designed to switch on and off with your headlights since they are for clearance…

The older generations of the Wesbar submersible low-profile lights came with sealed light bulb capsules that are not replaceable. If your capsule is sealed, then your best option is to replace the lights with new lights like part #403026 and #403076.…

When converting trailer taillights from incandescent to LED you do not need load resistors like you do when making same conversion on a vehicle. So the trailer light #TLL160RK does not come with them nor are they needed.

What you are experiencing is due to the fact that LED taillights only require a very small amount of amperage to illuminate. A tiny amount can cause them to illuminate. Trailer wring for the most part goes totally dead when the vehicle is off. But…

If the running lights and flashers are working on all the lights then it is not likely a problem with one diode. To determine what the problem might be you can do a little testing. Using a separate 12 volt battery you can connect the light directly…

Generally speaking, you can simply replace the incandescent tail light assemblies with LED tail light assemblies without any additional wiring. Almost all aftermarket tail light wiring and most factory harnesses accept both incandescent and LED so…

When a tow vehicle is equipped with a bulb-out sensor, the addition of LED trailer lights can cause hyper flashing like you describe because LEDs draw much less power than incandescent bulbs do. This fools the bulb out sensor into thinking that a…

Both the Optronics Trailer Lights, part #STL16RB, and part #STL26RB are able to go under water. The definition of waterproof means that the unit will not let water in after being under water for a certain period. Since both lights are LED lights, the…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.