Dimensions of Mounting Holes on Buyers Products Combination Pintle and Hitch Ball  

I attached a picture that has all of the mounting hole dimensions for the Buyers Products 10 Ton Combination Hitch with Mounting Kit #33710057 for you to check out. The distance between the two vertical mounting holes is 1-3/4 inches and the distance…

The correct hardware to use with the Buyers Products 3 Position Pintle Hook Mount part #337PM25812 will largely depend on what accessory will be attached to it. For example, the Buyers Products 10 Ton Combination Hitch with Mounting Kit part…

The standard 7-way trailer connectors have always had the same diameter. There isn't a smaller diameter size that's out there that your trailer would have and be causing the problems you mentioned. Most likely your best solution is to replace…

I went out to our warehouse and measured the Buyers Products Air Chamber and Plunger Kit #337PH50ACMK you were looking at. The bolt hole spacing on the mounting bracket measures 5-3/4" center to center, and the ovals measure 1-1/2" long.…

If you have the mounting area on the back of your semi, my recommendation is the Buyers Products Air Chamber And Plunger Kit For PH50/PH55 Series, part #337PH50ACMK. This plunger will use your trucks air brake system. I have included a product…

I have attached a photo of the Tow Ready Pintle Hook Mount, part #63059 with several measurements noted. As the photo shows, the length of the shank from the end to the front face of the plate is 14-5/8 inches. The plate is 5/8 inches thick so the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…