Do All Pintle Hitch Mounting Plates have the Same Hole Diameter and Spacing  

Hey Tim, From the center of the pin hole back to the mounting plate on the etrailer Bolt-On Swivel Mounting Plate #e52JR is approximately 1-3/4". The plate is 1/4" thick and portion that would sit under the frame extends out 1-3/4". If…

Hey there Gary, thanks for the photo and yes the etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin #e52JR will indeed work with your Round, Pipe Mount Swivel Jack #TJP-5001S-B.

The distance between the mounting holes of the etrailer Bolt-On Swivel Mounting Plate #e52JR that you referenced is 3-1/2 inches.

The B&W Pintle Hook Mounting Plate for 2 Inch Hitches #BWPMHD14004 referenced in your question has mounting holes that measure 1-3/4 inches apart on center vertically, and 3-3/8 inches apart on center horizontally. I have attached an image to…

Yes, you need to be as level as possible to attach a pintle mounting plate like the B&W Pintle Hook Mounting Plate #BWPMHD14004. My recommendation is to ensure you are level; I have added a link below to a help article which details measuring for…

If used in the rise position, the #63058 pintle hook mount would measure 11-1/2 inches from the bottom of the shank to the top of the plate. The tailgate clearance will depend on how far above the top of the plate the pintle would extend. With the B…

Yes the Curt Pintle Hook with 1-7/8" Hitch Ball #C48180 does fit on the B&W Pintle Hook Mounting Plate #BWPMHD14004. The pintle hook comes with install hardware too so with these two parts you'd have everything you need.

The B&W Pintle Hook Mounting Plate #BWPMHD14004 that you referenced has mounting holes with a 1/2" diameter. I went out to the warehouse and verified this.

You can measure either the outer diameter of the part of the dust cap that fits into the hub OR the inner diameter of the hub where the dust cap goes using calipers such as #PTW80157. Calipers are needed because the measurement has to be as accurate…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…