How to Determine Correct Vent Cover or Replacement Lid for Cargo Trailer  

We have actually spoken with Ventline regarding your model AS-13 M-VD0449 in the past and they have confirmed that the correct replacement cover is the part #BVD0449-A03 in Smoke or #BVD0449-A01 in White. The cover measures 14 inches x 14 inches…

The White Dome Assembly for standard roof Ventadomes #BVD0449-A01 doesn't use any hinge clips to install. It simply pops onto the hinge, as seen in the attached installation video below. If you're referring to the lift arm then…

The correct dome seal for the Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vents - White #BV0554-01 you mentioned is the Replacement Dome Seal for Ventline Ventadome Trailer Roof Vents #BVD0455-01. This will make sure you get a water…

Is there any way you could get me a picture of the top of the lid? Your picture is hard to identify since several look like that from the bottom. But with a picture of the top I know we'd be able to find what you are in need of.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

Hello Steve. It sounds like you have the ProTECHtor LP Gas Detector which is an older model that is unfortunately no longer available. We do offer a similar LP gas detector, but it is not a direct replacement. What we have is the RV Propane Gas and…