bing tracking image
Q & A Icon

Rear Passenger Sides Jacks Will Not Retract on the Lippert Ground Control 6-Point Leveling System

Question:

When I have tried auto level last 2 times the rear passenger side jacks go 1/2 way down and stop. The system goes throug auto level and says auto level success. Rear jacks not down.

0

Expert Reply:

I would first start off by double checking all connections on the controller, jacks, and touch panel. Once this is done you will want to reset the zero point. In order to do this for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC675817 you will need to follow the steps below.

1. Press the “CONNECTED” icon (Fig. 17A) at the top of the leveling screen quickly 6 times. Wait a few seconds until the gear icon with "OPTIONS" appears (Fig.18A ).
2. Press the gear icon with "OPTIONS" (Fig. 18A).
3. The screen will show "SET UP: Zero Mode Press Enter" (Fig. 19).
4. Press the “Enter button” (Fig. 19A).
5. The touch panel will present options for further leveling of the trailer if needed. The screen will also state "ZERO POINT CALIBRATION - Press Enter to Set" (Fig. 20).
6. Press "ENTER" (FIG. 20A).
7. Screen will show "Zero Point Stability Check ... Please Wait" (Fig. 21), followed by "Zero Point Set" (Fig. 22).

Once you have reset the zero point you will then want to try and use the auto level feature again. If it still doesn't work after the zero point is reset then please let me know and I will see if we can offer any additional troubleshooting advice.

click to enlarge
expert reply by:
0
Conner L

Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>