Troubleshooting Trailer Hitch that Seems To Short to Match Up to Frame Width
Question:
I drew it up with the bolts but it still doesnt touch the frame. is it made this way or should i use washers...not too happy with the MEXICO quality !!!
asked by: Larry
0
Expert Reply:
Sometimes hitches get bent in shipping. Especially if the hitch has a larger flange and is longer like the Draw Tite part # 75712. The solution for you would be to torque the hardware down without using washers. As long as there isn't any creasing or paint flaking on the hitch it's totally safe.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Hitch and Wiring for 2014 Jeep Patriot
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Q&A: Hitch And Wiring Availability For A 2025 Kia Sorento Hybrid SX-Prestige
- Q&A: Can a Jeep Patriot be Flat-Towed
- Article: Trailer Maintenance Schedule
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Why is the Curt Cam Buckle Stabilizing Strap Part # 18050 Needed
- Q&A: Trailer Wiring Harness for a 2008 Jeep Compass to Tow a Trailer with a 4-Way Connector
- Article: Trailer Hitch Installation Tips
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Bike Racks for Electric Bikes
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com