Where are Connectors on 2014 Dodge Ram 1500 that Are Used to Install Brake Controller
Question:
where is the factory wire for 2014 Dodge Ram 1500
asked by: Lutz
Expert Reply:
There are two harnesses under the dash of your 2014 Dodge Ram 1500 that are used for installing a brake controller. One carries ground, 12 volt power, and a circuit back to the 7-way of the truck and the smaller one carries just the stoplight circuit. Sounds like you are looking for the one that carries just the brake signal. For that you'll be looking for a small harness above the brake pedal. I attached a picture of where you'd find it but I the easiest way to see it will be to check out the install video I attached right at the 1:19 mark.
The harness used in the video is the part # 3023-P.
Product Page this Question was Asked From
Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Q&A: Where Does Red Wire of Brake Controller Install Harness 3023-P Install on 2014 Ram 2500
- Shop: Kenda 215/60-8 Bias Trailer Tire with 8" White Wheel - 5 on 4-1/2 - Load Range D
- Shop: Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Article: Trailer Wiring Diagrams
- Shop: Reese Strait-Line Weight Distribution w/ Sway Control - No Shank - 12 lbs GTW, 1,200 lbs TW
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Installing a Brake Controller in 2014 Dodge Ram Pickup
- Shop: Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 10,000 lbs GTW - Without Shank
- Shop: Curt Universal Wiring Harness for Vehicle-End Trailer Connectors
- Search Results: trailer brakes
- Search Results: trailer brake controller
- Video: Mount: etrailer Trailer Hitch Receiver on a 2019 Ram 1500 Classic
- Video: Feature Review 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket
- Q&A: Can a 2-1/2 WD Shank be Used with a System that Uses a 2 Shank
- Q&A: Recommended 2-1/2" Shank For Fastway e2 Weight Distribution Hitch FA94-00-1033
- Shop: Equal-i-zer Weight Distribution w/ 4-Point Sway Control - No Shank - 12,000 lbs GTW, 1,200 lbs TW
- Shop: Equal-i-zer Weight Dist Shank - 12" Long - 7" Rise, 3" Drop - 600 to 1,400 lbs TW
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Q&A: What Size Hex Bit do I Need for 3/4 Flat Head Socket Bolt?
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: How to Choose a Trailer Brake Controller
- Video: Finding the Right Trailer Wiring Harness
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Q&A: Lug Nut Torque Chart for Trailer Wheels
on Accessories and Parts
