bing tracking image
Q & A Icon

Can Stow N' Go Scissor Steps be Installed on Camper Without a Bumper

Question:

Installing stow n’ go steps on Bigfoot 25c10.6 with no bumper. I have a basement model truck camper from 2006. It has a recessed bumper and the current scissor step hooks onto a bracket above a basement door. Has anyone done an install video on a similar older model Bigfoot?

0

Expert Reply:

While we do not have a video of these steps being specifically installed on your camper I took a look at the instruction manual, which is also linked, and there is a method for installing these steps on a camper that does not have a bumper. You would need to remove your current bracket and it would require a 19.5" x 3.5" mounting area below the door.

The mounting bracket for each of these steps is 21-1/2" wide x 8-1/2" deep but its height is going to differ depending on the model you need; the height ranges are 12-1/2", 14-1/2", 17-1/2" and 19-1/2".

The correct model of Stow N' Go will depend on the entry height from your doorway to the ground.

- Entry height between 23-1/2" and 34-1/2": TorkLift GlowStep Stow N' Go Scissor Steps - 3 Steps # TLA7843

- Entry height between 31" and 42": TorkLift GlowStep Stow N' Go Scissor Steps - 4 Steps # TLA7844

- Entry height between 38-1/2" and 50": TorkLift GlowStep Stow N' Go Scissor Steps - 5 Steps # TLA7845

- Entry height between 46-1/2" and 58": TorkLift GlowStep Stow N' Go Scissor Steps - 6 Steps # TLA7846

click to enlarge
click to enlarge
expert reply by:
0
Kyle S

Products Referenced in This Question




Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>