Does Curt Hitch # C14006 Fit Under Bumper Beam of 2018 Chevy Silverado

Question

Question:

Does this hitch fit under the factory bumper mount? On my 2018 Silverado the bumper mount hitch is also the support for my bumper. Will this fit under the bumper mount and still keep the support for my bumper in tact?

asked by: Anthony M

0

Expert Reply:

The Curt hitch part # C14006 does fit your 2018 Chevy Silverado 1500 and does fit below the rear bumper support. I attached a picture that shows it installed on a truck like yours and you can see the bumper beam is still intact.

I also attached an install video for this hitch for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I went and grabbed both hitches that you referenced to get the dimensions you asked about. If you check out all the attached pictures you will see the dimensions you are looking for the Curt #C14006 and #C15323.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Does Curt Hitch # C14006 Fit Under Bumper Beam of 2018 Chevy Silverado

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching