Which Generation is the SolidStep Manual Fold-Down Steps LC791575  

I spoke with my contact at Gustafson Lighting regarding the RV Puck Light #277-000344 referenced in your question. This 4 Watt light produces 300 lumens and offers a nice, bright light. The overall dimensions on the unit are 4-1/2 inches in…

Yes, the SolidStep Manual Fold-Down Steps #LC791575 are compatible with doorway widths of 28" - 30" so they will work great for your application. Attached is a review video for you to check out.

The SolidStep Manual Fold-Down Steps for 26" to 29-7/8" RV Door Frames - Quad - Aluminum #LC791574 is made specifically for doorways that are in your 28 inch frame range like yours.

I attached a picture that I took from the install instructions for the Lippert SolidStep part #LC791574 that you referenced. Basically as long as you have room for the step assembly they get drilled on with self-tapping screws.

The threshold plate used on the Lippert SolidStep fold out RV steps like the #LC791574 is thin enough that it won't interfere with the opening or closing of your RV door. I've linked to a product demonstration video for you.

According to my calculations the distance from the center of the pin hole to the far end of the shank on Curt combo bar #E-9 is 3-1/2 inches. The bar is 6 inches long overall so from the center to the face of the receiver is 2-1/2 inches.

By threshold I assume you are either talking about threshold height or how the SolidStep fits on a threshold. If it was the latter then these steps do need to rest on the threshold of the door frame; I have added a cut out of the instruction manual…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Nathan, we have a solution with the MORryde StepAbove #MR26RR but the Lippert step you mentioned does not fit your RV doorway width. The MORryde StepAbove is basically the same thing made by a different company with slight differences.

Hey Rad, it comes down to what the door threshold height is of your camper which Torklift Glowstep would be correct for you. If the entry height is between 25-1/2 inches and 36 the part #TLA8103 would be correct. Here are the other height ranges if…