Will the Curt Class V # C15809 Fit 2006 Dodge Ram 2500 Mega Cab  

The factory hitch of your 2006 Dodge Ram 1500 has to stay on to install and use the Curt hitch part #C15809 that you referenced. You will need to install the bolts back through the hitch so that you can install the Curt hitch. If you wanted to do…

I spoke with my contact at Curt, who tells me that some Ram trucks, even though they were manufactured as pickup trucks were assembled using the spring mounts from the cab and chassis trucks. The Cab and Chassis truck spring mount would extend below…

I recommend using the Curt Trailer Hitch Receiver #C15809 for your 2006 Dodge Ram 3500. This is a Class V trailer hitch with a 2-1/2" receiver. It has a Gross Towing Weight (GTW) rating of 20,000 lbs and a Tongue Weight (TW) rating of 2,700 lbs.…

If you were to use an extension such as #C45048 with Curt trailer hitch #C15809 on your 2006 Dodge Ram 2500 then it would be limited to 4,500 pounds at the 34 inch length. But at the 24 inch length it is rated for 6,000 pounds and a standard length…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

The best image I could find of B&W hitch #BWHDRH25211 was in the instructions and it is a line diagram and not an actual picture. But it shows how the new hitch receiver will be directly beneath the factory receiver on your 2012 Ram 2500/3500.

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…