Bearing Kit Recommendations for 1989 Load Rite Boat Trailer with Seal 12194TC and Bearing L44649  

Hey Dave, what you gave me is enough info to get you replacement bearings. The grease seal 471750 matches the part #TMK48ZR. For a Timken replacement for the L44610 part number you'd need #TMK63VR. Then for a bearing for the L44649 you'd want…

I did some research and found that the 12194TC seal you said you have measures 1.250 inside diameter, and 1.979 outside diameter. The seal I recommend is part #34823. The dimensions listed for this seal are 1.249 inside diameter and 1.983 outside…

I have the Replacement Trailer Hub Bearing, #L44649, which has an inner diameter of 1.063 inches. If you need the matching race it is part #L44610. Our Double Lip Grease Seals, #RG06-010, have an inner diameter of 1.249 inches and an outer diameter…

I am sure we do and I would be happy to help you find the correct replacement bearing kit for your Triton LTWCI Trailer, but Triton does not advertise what size their bearings are and we do not have a breakdown of the specific components your trailer…

A 5.30 X 12C tire is going to be your best replacement. If you need the 4 on 4 inch bolt pattern #AM30780 is a good option, or #AM30820 for the 5 on 4-1/2 inch bolt pattern. These both have the wheel and tire included, which you'll need, since…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…

The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit #TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.

Hey Ian, the "no-step" you saw on the tandem axle fender kits we carry like the part #HP32VR is in reference to whether or not the fender setup has a step built into the top of it. These don't have that but in general they are strong…

Hey Tony, all of the components you mentioned would work as long as the axles you have are 3,500 lb axles. This is a very common axle capacity so I would assume that is what you have but you can check this by looking at the tag on the axle to verify…

Unless you want to completely clean out every bit of grease you will need to stick to a LMX red grease like item #L11390 that comes with the CE Smith Trailer Idler Hub Assembly item #CE13515. You can use your blue marine grease but you can't mix…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…