Header Connections Needed to Install a MagnaFlow Exhaust System on a 1968 Chevrolet Camaro
Question:
I will be hooking to long tube headers. Do you have the parts in stainless to do this?
asked by: Jim
Expert Reply:
As you have most likely realized, there will be some welding involved for the installation of the MagnaFlow Exhaust System, # MF15895, on your 1968 Chevrolet Camaro. You will need to find a flange that is compatible with your headers and have it welded to the front pipes that are included in the install kit, after they have been cut to the proper length.
If your headers do not have a flange and you need to create one, you could use a ball flange. We have 3 sizes of stainless steel ball flanges available, 2-1/4 inch # MF10743, 2-1/2 inch # MF10744 and 3 inch # MF10745. You will most likely need the 2-1/2 inch size for your Camaro.
Products Referenced in This Question
MagnaFlow Universal Ball Flange - Stainless Steel - 2-1/4" Diameter
- Accessories and Parts
- Exhaust Systems
- Ball Flange
- 2-1/4 Inch Diameter
- MagnaFlow
more information >
MagnaFlow Universal Ball Flange - Stainless Steel - 2-1/2" Diameter
- Accessories and Parts
- Exhaust Systems
- Ball Flange
- 2-1/2 Inch Diameter
- MagnaFlow
more information >
MagnaFlow Universal Ball Flange - Stainless Steel - 3" Diameter
- Accessories and Parts
- Exhaust Systems
- Ball Flange
- 3 Inch Diameter
- MagnaFlow
more information >
Product Page this Question was Asked From
MagnaFlow Stainless Steel Crossmember-Back Exhaust System - Gas
- Exhaust Systems
- Crossmember-Back Exhaust
- Gas
- Dual
- No Tips
- 2-1/2 Inch Tubing Diameter
- Stainless Steel
- Rear Exit - Dual - Straight - Both Sides
- MagnaFlow
more information >