Troubleshooting of JT's Strongarm Adapter that's too Wide to Install  

Can you send me a picture of the feet of your jacks? How far apart are they?

Thank you for your purchase from etrailer of the JT's Strong Arm Jack Stabilizer Kit for 5th Wheel RVs w/ 58" or More Between Landing Gear #LC191023. The orientation does not need to be chanced it is just rearranging the bars like you…

Yes, the Lippert Components JT's Strong Arm Jack Stabilizer Adaptor Lug #LC314592 that you referenced does come with the screws if you wanted to screw them onto the plate.

Two of the bars that come with the JT's Strong Arm Jack Stabilizer Kit for Travel Trailers #LC191025 install on the front landing gear legs like you can see in the attached picture and install video link on this page and the other two install on…

I went our to the warehouse to measure the eye to eye distance on the arms of the JT's Strong Arm Jack Stabilizer Travel Trailer Kit #LC191025. From the center of one eye to the center of the other it was exactly 26 inches.

Since you have electric stabilizers on your RV you would only use 4 of the arms that come with the part #LC191025. If you check out the install instructions link I attached you can see that your setup is shown in figure 3.

For your 2019 Jayco Jay Flight 32BHDS with heated underbelly, the JT's Strong Arm Jack Stabilizer Kit for Travel Trailers #LC191025 will fit and give you the stabilization you are seeking. The enclosed underbelly will not hinder the fit in any…

For attaching the JT's Strong Arm Jack Stabilizer Kit #LC191023 to front landing gear the needed brackets are included. I attached a picture that shows how these install to landing gear jacks on the front of a trailer as well as an install video…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

The Head Unit and R16 Roller Adapter #C16515 is more of an entry level fifth wheel head designed for a lower price point, whereas the A16 part #C16520 is a bit nicer with it's 2 piece jaw system that will provide better king pin contact which…

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…