Replacing the Jensen Stero JCD3007 with a Jensen Stero JWM10A  

Question:

Helpful Expert Reply:

The Jensen RV Stero part # JWM10A that you referenced requires around a 11" wide x 3" tall cutout which is fairly standard for single din stereos so there should not be much issue here. In regards to wiring, you will need to remove the pigtail you have used to install the Jensen RV Stero JCD3007 and replace this with the one that comes with the above using butt connectors part # DW05744-10 and part # DW05744-5. I have attached the pin-out diagram of each pigtail for you which should make the swap pretty easy.

expert reply by: Conner L

1

click to enlarge