Dimensions of Hitch Opening of Curt Hitch #13028
Question:
How far does the receiver protrude past a standard bumper and how far below the license plate on a 1973 Chevy K10 shortbed stepside? I am looking for about 1inch under the license plate and protrude 1inch past it. Is that possible?
asked by: Michael C
0
Expert Reply:
The hitch tube of the Curt Hitch part # 13028 is going to be right at 4-1/2 inches below the frame it connects to and the opening would then be right at 7 inches forward of the rear most mounting hole. You'd have to compare that to your vehicle to determine where that would place the hitch opening relative to your vehicle.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: hitch recovery
- Video: Hands-On with the Curt Tow Strap Loop for 2" Hitches
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Curt Tow Strap Loop for 2" Hitches - 13,000 lbs
- Q&A: Curt Trailer Hitch Receiver # C14082 Tube Height From Mounting Flange For 1973 Ford F-100
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: Distance from Mounting Bracket to Top of Receiver on Curt Trailer Hitch # C14082
- Q&A: Position of Hitch Receiver Tube for Curt Class III Hitch 13028 Once Installed on Truck Frame
- Q&A: Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
- Q&A: Will the Curt Hitch 13028 Fit a 1966 Chevrolet C10 with Aftermarket Bumper
- Q&A: What Is The Measurement From The Crosstube To The End Of The Receiver On The Curt 13028?
- Article: How to Measure for Trailer Hitch Drop
- Shop: Longview Custom Towing Mirrors - Slip On - Driver and Passenger Side
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: TorkLift StableLoad Suspension Upgrade w Quick-Disconnect - Lower Overload Springs - Stainless Steel
- Shop: Suspension Enhancement
- Shop: Air Filter
- Shop: Replacement Mirrors
- Shop: Transmission Cooler
- Shop: Towing Mirrors
- Shop: Catalytic Converters
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Trailer Wiring
- Search Results: hitch
- Article: Trailer Wiring Diagrams
- Video: Ultimate Overview of the No-Drill Mount for Electrical Mounting Bracket