Can Lippert Ground Control Leveling Jacks be Manually Operated  

I reached out to my contact at Lippert and they said that it sounds like you just aren't holding the 4 buttons for the reset long enough. It requires 5 seconds, but many people will count to 5 a little too fast and the system won't…

The correct replacement circuit and control board for your Lippert Electronic leveling system is the Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System #LC421484. This will be a plug and play solution, so…

Thank you for the picture of the module your Lippert Ground Control kit has as I can tell from it that you have a 4 point kit. So for a replacement control module you'd want the part #LC304136. The "points" refer to the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures…

To replace the Level Up controller on your 2012 Dutchmen Infinity 3750FL you need the Replacement OneControl Advantage Controller #LC88TF. I confirmed this is what you're needing with my contact at Lippert!

I have attached for you below the complete dimensions of the Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 part #LC349975 to the degree that Lippert was willing to share. If you require further dimensions, I'd need to know…

As long as the RBW Lil' Rocker mounts to industry standard base rails you'll need the Curt Adapter Rails #C29BR that fit in the OEM puck system on your 2019 Ram 2500 and give you a standard base rail connection. I'm attaching a photo…

The Replacement Right Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System- Qty 1 #LC344792 has the following dimensions:\ 99 inch diameter foot plate 23-1/2 inches tall without foot plate 8-1/2 inches wide at widest point…

You have two options to gain the clearance needed for the door to close. You can trim the door down like you mentioned or you can hammer the hinge plate lower. Lippert is actually who suggested hammering the hinge plate but they did say it would void…

The ID and Password you need to link your Lippert Ground Control 3.0 item #LC675817 system to the app on your phone can be found on the gateway inside your 2021 Cougar 290RLS. You have the antenna to connect wirelessly but if you don't have the…

The correct replacement leg will depend on your retracted height as well as the side the leg is on. We have the following available: -Replacement 24-1/2" Right Rear Leg #LC344792 -Replacement 22-1/2" Right Rear Leg #LC428493 -Replacement…