Can the Draw-Tite Front Hitch 65046 Be Welded To A 2008 Dodge Ram 2500
Question:
I have read the reviews on installation and was wondering if I can just have my welder weld it on?
asked by: Rick
1
Helpful Expert Reply:
Yes, you can have your welder weld the Draw-Tite Front Mount Trailer Hitch Receiver part # 65046 to the frame on your 2008 Dodge Ram 2500. The trailer hitch is designed to be attached via fasteners so the warranty would likely be void by welding but if done properly, this would most likely be more secure than the fasteners so I think you will be alright.
I have attached an install photo for you as well.
expert reply by:
Conner L
1
click to enlarge
Product Page this Question was Asked From
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Front Trailer Hitch for 2005 Dodge Ram 2500
- Q&A: Does EcoHitch or Curt 2024 Chevy Silverado 2500 Front Mount Receiver Sit Higher
- Q&A: Differences Between Curt C31017 and Draw-Tite 65046 on 2007 Dodge Ram Truck
- Q&A: Comparing Curt & Draw-Tite Front Mounted Trailer Hitch Receivers For a 2006 Dodge Ram 3500
- Q&A: Front Mount Trailer Hitch Receiver for a 2008 Dodge Ram 3500 Mega Cab
- Q&A: Which Front Mount Receiver for 2007 Ram 3500 Will Not Require Bumper Fascia Trimming
- Q&A: Best Hitch Mounted Spare Tire Carrier For a 2022 Ram Promaster Van
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Lighting Requirements
- Article: My Trailer Hitch Doesn't Fit
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Curt Echo Full Review
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Flat Towing Package for 2011-2014 Ford F-150