How To Use Rhino-Rack Vortex Aero Crossbars with Rhino-Rack Gutter Mount Legs On a 2011 Ford Van

Question

Question:

Will this allow my Rhino Rack Gutter mount legs RL150S10 to mate with my Rhino Rack Aero bars RRVA180B-2? The order I received from etrailer with these items do not mate up unless this is what I need to adapt. If so, Ill order these also. Thanks,

asked by: Paul

1

Helpful Expert Reply:

In order to install the Rhino-Rack Vortex Aero Crossbars part # RRVA180B-2 on your Rhino-Rack Roof Rack Legs part # RL150S10 you will also need to use the RLTP Leg Adapters for Rhino-Rack Vortex Aero Crossbars part # RRVA-FK1.

expert reply by: Conner L

1

Answer 1

You can install locks onto the Rhino Rack roof rack part numbers #RRVA165B-2, #RRRL150GMC-2, and #RRVA-FK1-2 that has been confirmed as a fit for you van, but you would need to buy that separately as part #RRVA-LEC4.

view full answer...

Answer 2

Aside from using a cargo basket with a fairing, like the Curt #C18115, which it sounds like you already did, my only other recommendation would be to use extra tie downs. You could use some additional tie-downs that you can find on the linked product…

view full answer...

Answer 3

The Rightline cargo bag, #RL100S20, should work just fine on your 2013 Toyota Venza. If you were to open the door, the clips would attach to the ridge directly above where the top of the door would be. Take a look at the picture I have linked. This…

view full answer...

Answer 4

The 65 inch long crossbars part #RRVA165-2 that you referenced would be long enough for the roof of your 2002 Ford Econoline and would work well with the Rhino-Rack Roof Rack Legs #RL150S10 that you also referenced. You would need to order a quantity…

view full answer...

Answer 5

Sounds like your Dodge Grand Caravan has sliding rear doors, what you would want to use with the part #RL100S20 that you referenced is the Car Clips part #RL100600 so that the strap doesn't have to pass through the door and interior of your…

view full answer...

Answer 6

Apart from how the rooftop bags mount there is little difference between the cargo bags that go on the naked roof of your 2013 Kia Soul or one that attaches to a roof rack. To avoid having to put a pricey roof rack on your Soul, I strongly recommend…

view full answer...

Answer 7

Yes, the square bars for the Rhino-Rack Gutter Mount Roof Rack you mentioned seeing for your 2011 Ford E350 Van can be swapped out for aero-style crossbars. For your Ford Van you will just need the Gutter Mount Legs #RL150S10 along with the 71"…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 10

For your setup I recommend the TrackTowers for Yakima Crossbars and Platforms - Track Mount #Y52AV which includes everything you need to mount Yakima crossbars to your Retrax cover (unless you plan on using the Round or HD bars - then you'll need…

view full answer...

Answer 11

The 71" Rhino-Rack Vortex Crossbars for Retrax XR Tonneau Covers item #RRVA180B-RRRLT600 are the correct set for your 2022 Ram 3500. These are made for full size trucks and fit in the rails of the Retrax PRO XR. These crossbars are exactly…

view full answer...

How To Use Rhino-Rack Vortex Aero Crossbars with Rhino-Rack Gutter Mount Legs On a 2011 Ford Van

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching