bing tracking image
Q & A Icon

No Power To Lippert Ground Control 3.0 Control Panel

Question:

Looking for reset button

0

Expert Reply:

I do have some things for you to check but there is not really a reset button for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System. The first thing you will need to do is obtain a multimeter. Once you have this then you will need to use the ground probe (black handle) and place that on the green wire coming from the back of the harness on the touch pad and then use the power probe (red handle) and place that on the black wire coming from the back of the harness on the touch pad. You should read 12 volts but if you do not have 12 volts you will need to trace these wires back while checking for shorts and then check the battery to make sure it is fully charged.

If you get 12 volts at the back of the control panel you are then going to want to check the communication signal. In order to do this you will want to use the ground probe and place that on the yellow wire and then place the power probe on the red wire. You should see between 5-7 volts here. If you do then you will need to replace the control panel part # LC421484. If you do not then most likely the control board will need replaced.

If you have the Lippert Components Ground Control 3.0 Automatic Leveling System part # LC358590 you can use the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System part # LC304136. If you have the Lippert Ground Control 3.0 Electric Fifth Wheel RV Leveling System part # LC675817 then you can use the Replacement Control Module for Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC346005.

expert reply by:
0
Conner L

Products Referenced in This Question




Product Page this Question was Asked From


Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>