What Vehicles Does Draw Tite Hitch part # 76286 Fit  

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C95CR will fit on 2021 Acura RDX, but with the factory trim piece it will not be very hidden. This receiver does offer a simple bolt-on installation process and requires no…

The crossbar of the Curt 13423, which we refer to as part #C95CR is exposed, just like the Draw-Tite #76268 would be. I've linked to a photo showing what the Draw-Tite 76268 hitch looks like once installed, the Curt #C95CR would look almost…

Correct, the Draw-Tite Max-Frame Trailer Hitch Receiver part #76268 which is a fit for your 2019 Acura RDX does indeed sit below the rear spare tire. Generally speaking, hitch manufactures will position the receiver tube so it does not stick out…

When installing the Draw Tite hitch part #76268 on your 2019 Acura RDX there is no need to remove any rear fascia or panels. It simply gets bolted into place and hangs below the rear bumper. See attached picture to see what it looks like installed.

The Draw-Tite Max-Frame Trailer Hitch Receiver part #76268 which is a fit for your 2019 Acura RDX with Advance Package will not impede the use of your hands free liftgate sensors. However, you will need to position your foot to either the right…

If you were to install both the Draw-Tite Max-Frame Trailer Hitch Receiver #DT79MR (76342) and #76128 on your 2022 Honda CR-V you'd find that the DT79MR is going to sit about 1/2" higher so these are relatively at the same height. With that…

The Draw-Tite Class III hitch you specified, part #76268 has two holes in each side of the receiver tube. The larger 5/8 inch diameter hole is meant for the hitch pin. The smaller hole is not used. So, in regards to your question-the larger hole is…

We personally don't have any photos as of yet (February 2019) as we haven't had a chance to install the Draw-Tite #76268 on a 2019 Acura RDX but I do have a picture from the installation instructions which I have attached for you to check…

We do have a hitch for the Touring model of the 2017 Honda CR-V. It is the etrailer Trailer Hitch item #e98848. This is the only hitch confirmed to fit the Touring model. As far as the foot activated lift gate sensor is concerned there is a…

I definitely have those measurements! I pulled the Draw-Tite Hitch #76268 from the warehouse and measured it for you. From the front of the hitch receiver tube, the center of the pinhole is 2-3/8". From the rear of the receiver tube, the center…

When installing the Draw-Tite Trailer Hitch Receiver #76268 on your 2020 Acura RDX you will remove the rubber isolator from the silver prongs (hanger) with either exhaust removal pliers or a simple pry bar. I have added a link to the instructions for…

According to the installation instructions for the Draw-Tite Max-Frame Trailer Hitch Receiver part #76268 which is a fit for your 2019 Acura RDX, the exhaust must be lowered temporarily in order to position the hitch up under the vehicle. If you are…