Locating Replacement Hubs for 2004 Four Winns Trailer

Question

Question:

I have a 2004 four Winns trailer and it has rear brake rotors. Can you send please tell me the hubs I need. I like to do all 4 hubs. Thank you

asked by: Josh

0

Expert Reply:

In order to determine the correct replacement hubs for your 2004 Four Winns Trailer you will need to pull one of the assemblies. Once you have the hub removed take out the inner and outer bearings and look for a number that should be stamped right inside of each of them.

If you can't read the numbers you can also take a few measurements along the spindle with a digital caliper. I have attached an image to assist.

If you can tell me the numbers you found, or the measurements you took, I will be happy to locate the right hubs for your trailer. It will also help to narrow down the options if you can tell me the trailer's axle capacity. Unfortunately trailer manufacturers don't typically make this kind of information readily available so this is the most accurate method to find the right parts.

expert reply by: Chris R

0

Answer 1

Often an axle's weight rating will appear on a sticker or plate on the axle beam itself, or sometimes the trailer's main identification sticker will include axle ratings. This is helpful unless of course the axles have been replaced during…

view full answer...

Answer 2

The replacement hub that you will want for your 2004 Four Winns boat trailer is part #AKIHUB-655-6-EZ-K. This is a 6,000-lb hub with the same bearings, grease seal and 6 on 5-1/2 inch bolt pattern as your current hubs. This hub comes with everything…

view full answer...

Answer 3

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 4

If you remove the hub and wipe away the grease on the spindle you can check to see if it is damaged. Look for an scarring, gouges, discoloration, or scoring on the spindle. If the spindle is damaged then the bearings won't ride properly and can…

view full answer...

Answer 5

I spoke with a representitive at TruXedo and they explained that the difference between the Telescoping Rack for TruXedo Elevate Rack System #TX84NV and the Telescoping Rack for TruXedo Elevate Rack System #TX24NV is that the CS is for compact size…

view full answer...

Answer 6

Hey Sean! As long as you don't have anything placing a draw on the Bright Way Solar Battery Charger #BRW54FR, and the 4-6 hours of sunlight is unrestricted then this kit will be just fine for keeping your Group 24 battery topped off.

view full answer...

Answer 7

I have a couple ways you can install the 7- and 4-Pole Trailer Connector Socket #HM40975 on your 2020 Ford F-150 with a 4-way flat factory connector. The first is going to be the easiest but is more costly. You will use the harness from the Curt…

view full answer...

Locating Replacement Hubs for 2004 Four Winns Trailer

Product Page this Question was Asked From

Continue Researching