bing tracking image
Q & A Icon

Replacement Bearings, Races, Seals, Brake Drums and Brake Assemblies for 4400 lb Axle  

Question:

I have a Cougar X lite 26 sab of the year 2012 with axle of 4400 lbs and I want to change the brakes of the 4 wheels. The distance between the holes is 2.816 2.7 / 8 up, down, right side, and left. It does not matter what I need. I also want to change the inner and outer wheel bearing as well as the seal .Which is the picece no.Thank you

1

Helpful Expert Reply:

The spindles used on the 4400 axle are compatible with the # L67048 Inner bearing and # LM67010 race and the # L44649 Outer bearing and # L44610 race, along with the 10-19 grease seal, part # RG06-050. You'll want to confirm this by pulling one of the hubs to check the reference numbers off of your current bearings.

For brakes, you'd need a 10 x 2-1/4 inch brake assembly. I'd recommend a Nev-r-adjust assembly, part # K23-478-479 for the right and left sides. Typically, it's recommended to replace the brake drums and assemblies at the same time, so that the brake pads and magnet will have perfectly flat and true surfaces to work against. If you decide to replace the drums as well, the bearings, seals grease caps and lug nuts are included. That part number is # 8-407-5UC3-EZ

expert reply by:
1
Mike L

Products Referenced in This Question








Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>