Wire Gauge Of Optronics LED Combination Trailer Tail Lights TLL16RK  

I reached out to my contact at Optronics and they were able to give me some additional information on this light set. The LED Combination Trailer Tail Lights #TLL16RK have full copper wires that are 18 gauge wires.

Hey Isaac! While we don't have one specific all in one kit we do have every component you will need to update your trailer's lighting and brakes. I recommend using the Trailer Wiring Kit item #ET7WK. This includes a 7-Way connector, a…

The older generations of the Wesbar submersible low-profile lights came with sealed light bulb capsules that are not replaceable. If your capsule is sealed, then your best option is to replace the lights with new lights like part #403026 and #403076.…

For that we have the Waterproof, Over 80" LED Trailer Light Kit with 25' Wiring Harness #TLL16RK which comes with all new wiring, taillight assemblies, and a license plate bracket.

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Hi Ray, the bolt hole spacing for the etrailer Electric Trailer Brakes #AKEBRK-35-SA is 2-7/8" on center, so these sound like they'll work perfect for you.

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt pattern…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…