Replacement Mounting Hardware for Older Thule Pull Top Ski Rack

Question

Question:

Have what I believe is an older Thule pull top style ski rack model 853-2805, need mounts for it and round nuts as well, mounting to oem style bars eliptical on a 2010 mazda cx-9 - Will 7521241001 speedlink system fit my racks? Is it considerably faster to install/remove than the 2 options below? Quicker to move from one car to another? - What is the difference between etrailer part TH7520970001 and Thule 7533998, is it that TH7520970001 includes round nuts 853-5439? - I assume both systems TH7520970001 and Thule 7533998 are meant to be left on after installed and not removed/moved from car to car, correct? Thank You

asked by: John

0

Expert Reply:

To determine which Thule replacement hardware you'd need we have to know which Pull Top you have. The part # 7533998 is for the TH725 and the part # TH7520970001 is for the TH726 both of which are discontinued.

Since you said you also need the round nuts you'd need the part # 853-5439 and most likely need the # 7533998. There isn't a way we can help you install the speed link setup though. The hardware is meant to be left on the rack when installed and uninstalled.

expert reply by: Jameson C

0

Answer 1

The Replacement 13 mm SpeedLink Mounting Hardware Assembly #7521241001 will indeed be a good fit for your crossbars. The straps on this adapter are made to be universal, and are known to fit crossbars like the Thule Wingbars, which are about 79 mm…

view full answer...

Answer 2

Thank you for the information and the photos! According to what you sent in it looks like you have one of the discontinued Thule Flat Top (TH91724 or TH91725) or Pull Top (TH91726) carriers. These came with universal mounting hardware as well as an…

view full answer...

Answer 3

The Mounting Kit for Thule Flat Top Rooftop Ski and Snowboard Racks #7533998 comes with 8 screws of one size, 4 screws of another length, 4 washers, and 2 tools. If you need the round nut that you saw in the instructions as an additional security…

view full answer...

Answer 4

The correct bolt you need for your Thule roof ski rack is the part #853-5269 that you referenced. The correct replacement tool you'd need is the part #853-5270-02 as well.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Don't worry Dave, we have everything you need. The Malone LowBed MicroSport Trailer #MPG464-LB will allow you to carry boats up to 20' long and can support up to 500lbs on the crossbars. So with the Bunk Kit #MPG561 and 2 Bike Racks #MPG2100…

view full answer...

Answer 7

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

view full answer...

Replacement Mounting Hardware for Older Thule Pull Top Ski Rack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching